Don't know what year you have, but on I believe it's the 98+'s you can
pull the codes from the PCM by doing the following:
1) Put the Key in the ignition
2) Turn the key to the "Run" position (The one right below start)
3) Move back to the "On" Position
4) Turn the key to the "Run position
5) Move back to the "On" position
6) Turn the key to the "Run position
7) Move back to the "On" position
The codes will appear in the odometer, flashing the codes, one by one,
and then it will flash "P DONE" when you've reached the end of the
codes.
There are ways to do it on older trucks (I may be wrong), but somebody
else will have to pipe in and give you a hand on that one!
Thanks
william
-----Original Message-----
From: owner-dakota-truck@dakota-truck.net
[mailto:owner-dakota-truck@dakota-truck.net] On Behalf Of taylor9565
Sent: Monday, March 25, 2002 4:25 AM
To: dakota-truck@dakota-truck.net
Subject: DML:RE: pull codes without a code scanner??
AUTO ZONE can pull the codes for free with a scanner
and look up the code, no charge!!!!
Ron-
2001 Dakota Sport R/C bright silver met
http://www.twistedbits.net/WWWProfile/dakota/K12X33hlXkiTk
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:04:13 EDT