On a related topic, just how do you use a MIG to weld up an exhaust
when its already on the vehicle? I've seen shows on TV and such
where they're welding up an exhaust system, but they only show a short
clip and don't actually show them welding ON TOP of the exhaust pipe.
I haven't worked on a vehicle yet where there's enough room to get
the gun up above the pipe. How is that done? I'm guessing you weld
up the bottom and then loosen up the pipes enough to pull it down and
get some clearance?
---Jon-
.---- Jon Steiger ------ jon@dakota-truck.net or jon@jonsteiger.com -----. | I'm the: AOPA, DoD, EAA, NMA, NRA, SPA, USUA. Rec & UL Pilot - SEL | | '70 Barracuda, '92 Ram 4x4, '96 Dakota, '96 Intruder 1400, '96 FireFly | `----------------------------------------- http://www.jonsteiger.com ----'
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:04:22 EDT