Hey all,
I've officially started the stroker project. I'll be stroking my 318 to 390
cubes. But I was wondering, how will original compression ratio affect
putting a SC on later. The stroker kit I'm putting in uses diamond forged
pistons with a 9.4:1 compression ratio, will I need to do anything to
compensate for the "higher than stock (which was 9:1)" in order to drop a SC
on later? Also, i was going to order the I-beam rods (because they are
lighter) but was wondering if I'd be better off getting the stronger (but
heavier) H-beam rods if I'll be SC'ing it later? or will the I-beam rods work
just fine?
Thanks
John S
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:04:42 EDT