That's what an ASE in brakes gets you.... You can also use a smaller
C-clamp with that method as well. Personally I just jam a flat blade
screwdriver between the outside pad and the rotor and pull it most of the
way (if not all) before I remove the caliper. Remember, don't let the
calipers hang by the brake lines for too long it could cause problems later.
I bent up an old coathanger that I hook onto the wheel well to hang the
caliper from. Works great and the best part is that it's FREE.
-- -Josh 2000 Dakota CC 3.9L""Rick Barnes"" <barnesrv@attbi.com> wrote in message news:002401c2c225$4d5a3090$0200a8c0@sys15... > > Josh, great advice about leaving the old pad on. > Rascal > > Subject: DML: Re: Re: How to put new rowders and break pads on my weels. > > Other than that, the only "special tool" is a BIG C-clamp ( 7-8") to > > compress the piston in the caliper. > > Just remember to get that piston in there straight. I find it's easiest to > do when you leave that one pad on.
This archive was generated by hypermail 2b29 : Fri Feb 06 2004 - 11:45:45 EST