Hey Tom I went to Chuck's site but I didn't see any instructions. I didn't
even see the part numbers but I did get the correct part numbers. Anyone
else have some input?
Thanks
Sam
"andy levy" <andylevy@yahoo.com> wrote in message
news:b6vfhn$mho$2@bent.twistedbits.net...
>
> Terrible Tom wrote:
>
> > I remember reading someones web page where they detailed the steps they
> > took to replace the ball joints - I think they drilled out the stock
> > rivits and used a nut/bolt combo (threadlocker obviously used)
>
> I think Chuck Robbins did it. http://www.intense99dak.com/
>
>
> --
> -andy
>
> http://home.twcny.rr.com/andylevy/ --- andylevy@yahoo.com
> --------------------------------------------
> "Whatever Adam does, do the opposite and you'll be fine"
> -Bob Tom
> --------------------------------------------
>
This archive was generated by hypermail 2b29 : Fri Feb 06 2004 - 11:46:10 EST