Umm...yea. :) Well the reason I asked is so I wouln't have to spend time and
money buying an inclinometer and taking measurements. I know HOW to figure
it out but was hoping someone has already done this and can share the info.
;)
James
-----Original Message-----
From: owner-dakota-truck@bent.twistedbits.net
[mailto:owner-dakota-truck@bent.twistedbits.net] On Behalf Of KenCo
Sent: Friday, July 02, 2004 7:12 PM
To: dakota-truck-moderator@bent.twistedbits.net
Subject: Re: DML: Pinion Angle
James Calder wrote:
> What degree wedge plates should be used on a 3" lowered rear via leaf
> springs to correct the pinion angle? Summit has 2, 2.5, 4, and 6
> degree plates. This is on a GenII.
> Thanks,
> James
use an inclinometer (floating angle gauge) to measure the trans or rear
hanger in deg., then
2-5 deg. offset off that yoke for the driveshaft then adj. rear w/ wedges
for same offset so the U-Joints wear correctly AND this is all done at
normal ride height w/ tires on equal height blocks if needed not jacked up.
sometimes a spacer is needed at trans mount or you may need to reposition
the hanger holes to get the right interference angle at ea. end.
you can wear out U-Joints in 5-10k miles if its not done right or at least
close.
-- -- http://www.kencofish.com Ken Arnold, 401-831-5739 cell 401-225-0556 Importer/Exporter of Goldfish,Koi,rare Predators Shipping to legal states/countries only! Permalon liners, Oase & Supreme Pondmaster pumpsLinux (SuSE 8.2) user #329121 Please Note: No trees or animals were harmed in the sending of this contaminant free message We do concede that a signicant number of electrons may have been inconvenienced ;)
This archive was generated by hypermail 2b29 : Sun Aug 01 2004 - 00:46:14 EDT