>From: "Bernd D. Ratsch" <fasstdak@hotmail.com>
>
>Put the truck up on ramps (or a lift of you have access to one). Remove
>the
>three bolts on each motor mount (block side) - make sure you have a jack
>under the balancer to support it (do NOT use it to lift the motor too
>much...just as a support). Remove the two nuts for the long bolts running
>through the frame-side of the mounts and then remove the mounts. Reverse
>the process and you're all done.
>
>- Bernd
It's that easy? It looked like a PITA to me. Can i do with with regular
hand tools Ie: Sockets, wrenches, and a BMF Hammer? Also how much should
those mounts run $? And are there any aftermarket ones that are better than
the stock ones?
--Hop
http://home.swbell.net/hopsdak/dak.html
This archive was generated by hypermail 2b29 : Sat Jan 01 2005 - 11:48:08 EST