I know. I e-mailed you directly earlier with a question about it. :)
----- Original Message -----
From: <jon@dakota-truck.net>
To: <dakota-truck-moderator@bent.twistedbits.net>
Sent: Tuesday, July 17, 2007 4:25 PM
Subject: Re: DML: RE: Re: RE: Headers
>
> "Ray Block" <bpracing@worldnet.att.net> wrote:
>
>>> -----Original Message-----
>>> From: Tom Byrne
>>>
>>> Any luck with the part number?
>
>> Nope. Just finished searching. You have a couple options I can think
>> of.
>> A good/helpful dealer's parts guy should be able to find it....perhaps in
>> an
>> export book. I've had mine so long I don't remember where we found it.
>
>> You'll want the EGR block off plate and gasket for a '92-93 5.2 magnum
>> exhaust manifold. Or...you can have it made from some scrap 1/4" steel
>> plate. I use stainless bolts and nuts on mine.
>
>
> I believe the Mopar part number for the gasket is 53010000. I'm
> not sure about the block-off plate though, I didn't realize that Mopar
> even sold one.
>
> Shameless plug: I actually do sell an EGR block-off plate for
> about $10. Its 1/4" aluminum and comes with two grade 8 bolts in a
> black oxide finish. (The bolts have the finish, the plate itself is
> raw aluminum.) It does not include the gasket though, so you'd
> need to buy one from the dealer (or perhaps an auto parts store would
> have one), or you may be able to get away with just using some Ultra
> Copper RTV instead of the gasket, or find some old header gaskets and
> cut one out.
>
>
> http://www.steigerperformance.com/dif.cgi?sp01010
>
> --
> -Jon-
>
> .- Jon Steiger -- jon@dakota-truck.net or jon@jonsteiger.com -.
> | '96 Kolb Firefly, '96 Suzuki Intruder, Miscellaneous Mopars |
> `-------------------------------- http://www.jonsteiger.com --'
>
>
This archive was generated by hypermail 2b29 : Wed Aug 01 2007 - 00:15:21 EDT