At 02:31 PM 8/16/97 EDT, you wrote:
>
>Does anyone know of anyone making running boards for the '98 (I guess same
as '97)
>Dakotas? I do not really want the nurf bars or the ones that look like
ground effects
>with a place to step. Nor do I want the bright diamond cut work truck
boards. I am
>looking for a good sturdy step (black) that goes wheel well to wheel well,
with the
>moldings on each end. (No, I'm not picky :)). I do like the ones on the
Toyota 4-Runners,
>but the Toyota dealer said that they do not sell that particular one for
aftermarket
>purposes and that they are made specifically for their trucks. (Big
surprise, but I
>thought that I would try). I did find some by DeeZee (black extruded),
but they did not
>go from end to end...too short and I have the fender flares that come with
the wheel and
>tire package, so the boards are not made to tie into the fender flares.
Any suggestions??
>
>Holly Gardner
>'98 Black Dakota "Sport" 4x4, V-8, 5-speed, CC, etc. (Still loving it!!)
>---------------------------------------------------------------------------
-----
> (__) ,---------. NOTE: The preceding message was sent via Jaek
and
> (oo) | :\/: _ _ \ Jon's WWW mail cow gateway. That is to say, the
> /-------\/_/ : :: :: : ) person who sent this message could in fact be
an
> / | MAIL|| \_ ' '`-'`-'/ anonymous prankster. Even though this message
was
>* ||"" || \__________/ mailed to you from the cs.fredonia.edu domain, it
> ^^ ^^ could have been generated by anyone in the world.
>Please keep this in mind. Thank you! --Jaek (smit2204) and -Jon- (stei0302)
>---------------------------------------------------------------------------
-----
>
>
>
Have you looked at the Mopar Accesories for the Dakota? They have about 3
designs.
Rob Carmack
rob@notnow
Deep Amethyst, '98 Dakota Sport, CC, 4x2, 5.2L 318, 5spd, 3.55 SG
Deliv. Early Sept.
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:07:50 EDT