I doubt if it will make any difference because I've seen trucks with lift
kits in them that just had a block between axle and the springs and the
springs overhung the blocks by about a 1/4" on either side (Compared with
an 1/8" with the lowering block), so I doubt it would really matter with a
lowering block either...
Bruce
>
> I'm getting ready to order some 2 inch lowering blocks for the rear of
> my truck and I saw a pair in the Summit catalog that look nice price
> wise. They come in 1, 2, or 3 inch drops and they are 2.25" wide. The
> catalog says that the blocks should be at least as wide as the leaf
> spring. I measured my spring and it is 2.5" wide. Will this make any
> difference? The springs would only overhang the blocks by a hair on
> each side.
> --
> ----
> Michael Clark mike@snakebite.com
> '93 MarkIII 4X2 V-8 SWB RC auto, DDBC
> K&N FIPK, Flowmaster cat-back dual, MP SBEC
> Doug Thorley Headers, Moroso Blue Max wires
> 180 degree thermostat, WaterWetter, Brass cap & rotor
> one and only 1/4 mile time of 15.08 @ 90.82
> My Dakota page=> http://userv.wt.net/~mclark/dakota.html
> Dakota Webring=> http://userv.wt.net/~mclark/webring/ring.html
>
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:08:10 EDT