} << tires on widened stock wheels, or maybe some 97-98 15X8 aluminum Dakota
} wheels. >>
}
} This is what I want to do to the aluminm 15x6.5's from the factory also. Where
} can I get them done?
} George
Dodge never put 6.5" wide aluminum wheels on a Dakota. If you have a
pre-'97 they are 6" wide, as is marked on the inside of the rim. Rim
width is measured INSIDE the rim flanges (hard to do with the tire on).
} Widening aluminum ? Sounds fun .
} >
} W . Jack Hilton III
I've seen widened aluminum rims for motorcycles, but those were
extruded, not cast. They would have to put the extra on the outside or
it would have too much backspacing. This would cost a fortune if it can
be done at all. Cheaper just to buy new rims. Too bad, I like the look
of the stock "Predator" wheels.
-- Frank Ball 1UR-M frankb@sr.hp.com (707) 794-4168 work Hewlett Packard (707) 794-3038 fax (707) 538-3693 home 1212 Valley House Drive Kawi KDX200, Yamaha XT350 YZF600R Seca 750 Rohnert Park CA 94928-4999 '95 Dakota SLT Club Cab V8 5-Speed 2WD
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:08:56 EDT