In a message dated 98-08-08 22:20:06 EDT, you write:
<< than Chrysler who want 2 arms and 2 legs a piece for thiers)? I have the
stock bench in it now and it really sucks on long trips. I keep hounding
the junkyards for a wrecked or blown Dak w/buckets but I've had no luck.
It's been a couple years now and I'm getting closer and closer to handing
the money over to Chrysler. Has anyone else replaced thiers?
Thanks,
Jeff
>>
Find a mid 80's Daytona Turbo. The lumbar support seats bolted right into my
96. The top of your post got cut off, so I dont know what year truck you
have. If its a 97, not sure if the seats will work. Anyways, all the holes
were already in the floor of my truck. All I did was use the left seat track
from the bench seat on the left side of the drivers bucket. Then on the
passenger side, I used the right bench track on the right of the passenger
seat, and the left track from the DRIVERS bucket seat on the left of the
passenger seat. The seats look good, and are real comfortable. They are
fully reclining and have full lumbar support. I got mine in black velour with
a grey and black checkerboard pattern down the center. I have seen these
seats in multiple colors in both leather and velour. Much easier to find then
Dak buckets.
Brad
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:09:19 EDT