That's still a pretty good pull considering only minor mods. Just
one question. Are you sure about the torque numbers? They seem
a little low. Shouldn't they be higher than the HP?
Anyway, nice pull.
Ryan K
'99 R/T RC
Alan Short wrote:
Alan Short wrote:
>
> Hello all, went to the dyno this A.M. to make a pull on my '98 R/T.
> Fortunately, Eric (swede) used the same dyno a few months ago on his '99
> R/T. Eric's stock baseline #'s were: 190.5 hp
> / 248.9 ft. lbs.
> My R/T with mods: 272.0 hp / 280.6 ft. lbs.
> Better than I would have guessed, my mods are: JET II chip, 180 Stat,
> Elec Fans, MP Headers/y-pipe, ported throttle body. Impressive as it may
> sound, it isn't a lot faster than stock. Lots more bottom end, but
> doesn't G-Tech any faster over the 1/4. I don't necessarily put stock in
> the G-Tech #'s, that's why I dyno'ed it. Track opens in a couple weeks.
> I'll post my new times. Alan S.
After further studying, I have to ammend the dyno #'s. I gave hp/ft.lb.
PEAKS which take into consideration shift shock. The # sheet is also
different in format from Swede's. Mine is a line graph, his is a list by
rpm/100's from 3,700 to 4,900. My line graph has the real hp/ft.lb. #'s
in blue for pull # 1 & red for #2.
Best pull was #1 with 250.8 hp/229.1 ft.lbs
I thought 272/280 was a little high. I wish. Alan S.
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:12:11 EDT