In a message dated 2/5/99 3:16:10 PM Eastern Standard Time,
martindt@pacbell.net writes:
<< Ron,
I lowered my R/T 1". The U-bolts that came with the ground
control kit were 3". The R/T
axle is 3 1/2". BTW don't go lower than 1". I tried 2" and it bottoms
out and is too low. I cut the bump stops and you'll hit the exhuast atv
2". 1' levels it out and looks great. BTW the support at ground control
is great. The kit from summit is not a direct fit the center pin has to
be filed and the
u-bolts are too small. Maybe the bell tech kit is a direct bolt on. >>
Martin, How did you get the 3" ground control to work on the R/T's 3 1/2"
axle? Did you buy the kit from summit? How much did it cost?
Charles Smith
99 Dak R/T
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:12:32 EDT