Bob,
I think pretty much the only way to go when lowering the rear is with a
notch, after measuring everything it look slike one should be used even a 4"
kit. I'll definately get some pictures up when its done
Looking forward to the rivets,
Rick
98 Black RC
Bob Nichols wrote
> Hey Rick, Nice time getting the front done. Are you doing the c-notch in the
> rear?
> When you do the rear rivits, drill em up to about 3/8, about 1/4" deep then
> wack em off with a chisel. An air chisel is a big help. Send pictures when
> your done.
> Good Luck, Bob
> --
>
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:13:48 EDT