Re: Water neck for M1/MPI manifold Was: F&B TB Stage 2

From: James Harmon (jdharmon@earthlink.net)
Date: Sat May 22 1999 - 00:56:39 EDT


Jon,
Besides the neck, what problems with mounting the air sensor did you or anyone else
encounter?
I should have my manifold alter this or middle of next month. Any suggestions on
the install - parts list, specific problems?
Jim

Jon Steiger wrote:

> At 11:39 PM 5/21/99 , you wrote:
> >In a message dated 5/21/99 6:56:48 PM Pacific Daylight Time,
> >stei0302@cs.fredonia.edu writes:
> >
> ><< BTW: Summit has a water neck (P/N SUM-377806) that works great! Well, I
> > haven't actually bolted it onto the engine and flowed coolant through it,
> > but I've heard good things about this type. (It uses an O-ring instead of
> > a gasket.) Its chrome, and the looks and workmanship are a heck of a lot
> > better than the cast iron junk you'll find in a parts store.
> >
> > >>
> >
> >
> >Is it straight, and long, like the original Magnum one?
> >
>
> No, its pretty short compared to the Magnum one, but it seems to be
> longer than the cast iron one I saw at Autozone. Its 2" long, total. The
> base is about 1/4" high, and the neck is about 1 1/4". The neck has a
> diameter of about 1 1/2" except at the top where there is a lip which is 1 5/8"
>
> -Jon-
>
> .--- stei0302@cs.fredonia.edu ------------------------------------.
> | Affiliations: DoD, EAA, MP Race Team, NMA, SPA, USUA. RP-SEL |
> | '96 Dodge Dakota v8 SLT CC (14.58@93.55), '96 Kolb FireFly 447 |
> `----------------------- http://www.cs.fredonia.edu/~stei0302/ ---'



This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:14:08 EDT