Yes you can. I've already done it several times.
It takes a bit to get the ON/OFF procedure right....but it DOES work.
----- Original Message -----
From: W. Jack Hilton III <HEMI@charter.net>
To: <dakota-truck@buffnet.net>
Sent: Tuesday, May 25, 1999 9:38 PM
Subject: Re: DML: OFF and ON to get codes..? doesn't work?
>
> You can't pull the codes manually in a 97+ truck .
>
> Say thank you to OBD II .
>
> :)
>
>
> At 10:46 PM 5/25/99 EDT, you wrote:
> >In a message dated 5/25/99 7:56:33 AM Central Daylight Time,
bernd@texas.net
> >writes:
> >Hey,
> > I took ur advice and cycled thru many times and it didn't work. it
> >just stayed at the regular mileage reading i have a 97 dakota v6. is
there
> >anything wrong?
> >-Dester
> >
> ><< Cycle the ignition from OFF to START three times and keep it in the
START
> > position on the third time. You'll see the codes appear on your Digital
> > Odometer. 12 is normal and then the rest...if there are any. The DML
> > Homepage has a link to tech stuff that has this process documented.
Hope it
> > helps...worked for me on my '97.
> > >>
> >
> >
> @@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@
>
> W. Jack Hilton III
>
> HEMI@charter.net
>
> http://webpages.charter.net/hemi/jbd1.html
>
> ICQ#: 32611901
>
> AOL Instant Messenger: "DwnSth69"
>
> @@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@
>
>
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:14:09 EDT