I just got some Monroe Sensatraks, great shocks, but the rears where
a bitch. Thed expand before I could cram em in, also the exhaust pipe got in
the way, had to remove end section, install shock, reinstall end section, no
rubbing when in, but couldn't angle them in with the pipe there? Am I the
only one with this problem.
Then theres the front shocks, finally got the nut off the pass side,
but the drivers side is so rusted on there I don't what to do? any
sugjestions (yes I do have the removal tool)
Greg
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:14:56 EDT