Actually, welding a sheet of stainless (special
flux, gas needed to do this!) would be MUCH better,
stainless is a poor heat conductor, where the aluminum
is a very good thermal conductor.
> bathtub gasket that makes up the bottom of the intake, with hot oil
> splashing on the bottom of the gasket... I know there's a gain to be had
> just by sealing up your stock intake- having plate aluminum welded to the
> bottom of it would work great for this purpose...
Mike
-- "Thoughtcrime was not a thing that could be concealed forever. You might dodge sucessfully for a while, even for years, but sooner or later they were bound to get you." - George Orwell, Nineteen Eighty-Four
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:14:58 EDT