can u tell me which wires would hook up where on the relay? there are no
schematics on the relay or anything. i already have a master switch :-)
gotta find a place to hide it...
>From: "Jon Smith" <jon@fast4x4.net>
>Reply-To: dakota-truck@buffnet.net
>To: <dakota-truck@buffnet.net>
>Subject: DML: Re: nx kit install
>Date: Sat, 1 Dec 2001 17:27:41 -0500
>
>mike, the fuel does connect to the fuel rail, you'll need to remove the
>schrader valve inside the rail. The relay hooks up downstream of the WOT
>switch.
>
>when the circuit is closed, power will 'flow' from the 12V source, to the
>WOT switch, to the relay, to the solenoids. You may want to install a
>second "master switch" inline b/w the 12v source and the WOT switch.
>
>That way you can floor the gas from idle, then flip the switch when you
>want
>the n2o to kick in (above ~2k or 2500 rpm)
>__________________
> Jon Smith
> Raleigh, NC
>'95 CC 318 4x4 auto
> 344rwhp/424tq
>----- Original Message -----
>From: "Mike Turner" <donkeydan69@hotmail.com>
>To: <dakota-truck@buffnet.net>
>Sent: Saturday, December 01, 2001 3:43 PM
>Subject: DML: nx kit install
>
>
>does the fuel solenoid imput connect to the fuel rail purge? and does the
>relay hook up to the solenoids and the WOT switch? i need some answers.
>
>thanks in advance
>mike
>
>_________________________________________________________________
>Get your FREE download of MSN Explorer at http://explorer.msn.com/intl.asp
>
>
>
_________________________________________________________________
Get your FREE download of MSN Explorer at http://explorer.msn.com/intl.asp
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:03:39 EDT