Cal Hyer,
I guess the engine is not a good starting point.
Thanks for your help.
Paul
1999 Solar Yeller 99 Dak
Scotia NY
-----Original Message-----
From: Cal Hyer <clhyer@hom.net>
To: dakota-truck@buffnet.net <dakota-truck@buffnet.net>
Date: Wednesday, January 02, 2002 8:21 PM
Subject: DML: Re: 1999 Dakota Solar Yeller
>Paul,
>This is a fairly simple process:
>1. Disconnect battery ground cable
>2. Remove the cluster bezel (front dash & instrument panel cover)
> a. With an automatic, set the parking brake & shift trans to 1st gear
> b. With tilt steering, tilt all the way down
> c. Grab the top of the cluster panel and pull straight out towards you,
>just enough to clear it from the snap clips
> d. Gently pull around the edges to unsnap all the clips
> e. It will come out at this point
>3.Two screws secure the radio to the dash, looking straight at it, they are
>in the top right and lower left. Take out these two screws.
>4. Pull the radio out and disconnect the wiring harness (2 clips), ground
>wire and antenna.
>
>Installation is the reverse. Book says the 2 screws holding the radio in
>should be tightened to 45 in. lbs.
>Good luck,
>Cal
>
>
>----- Original Message -----
>From: Paul Brino <campman2@worldnet.att.net>
>To: <dakota-truck@buffnet.net>
>Sent: Wednesday, January 02, 2002 7:51 PM
>Subject: DML: 1999 Dakota Solar Yeller
>
>
>> I was wondering if there was a connect with dots instructions on how to
>> remove my factory
>> installed radio from the dash? If I don't have a starting point, the
>engine
>> might be the first place I start.
>> Please help this Dak owner that still has his truck transmission being
>> overhauled at Scotia Motors. So I
>> ordered the Pioneer super tuner III today since, I needed to take my mind
>> off the transmission.
>>
>>
>> Please help.
>>
>> Paul
>> 1999 Solar Yeller Dakota V6,
>> Scotia, NY
>>
>>
>
>
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:03:47 EDT