Ball Joints

From: Sam Hotmail (samjperez@hotmail.com)
Date: Thu Dec 12 2002 - 12:12:07 EST

Next message: Ron Sobers: "Re: Re: RE: Dakota with a gooseneck??"
Previous message: Russ Borman: "What does your trans run at?"
Next in thread: Wisotzkey, Rich: "RE: Ball Joints"
Maybe reply: Wisotzkey, Rich: "RE: Ball Joints"
Reply: Josh Battles: "Re: Ball Joints"
Reply: Rick Barnes: "RE: Ball Joints"
Maybe reply: Shane Craven: "RE: Ball Joints"
Reply: Kevin Reimer: "Re: Ball Joints"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Mail actions: [ respond to this message ] [ mail a new topic ]

While changing my oil this weekend I noticed that both ball joints, upper
and lower on both sides could use a little grease. However I noticed also
that neither has a nipple to attach the grease gun to. So I went to the FSM
and it says that if equipped then you can grease them. But how do you grease
them if not equipped. Any help would be greatly appreciated. My thoughts go
to Sir Bill as he recuperates.

Sam
'00 Back Dakota Sport 4.7L

Next message: Ron Sobers: "Re: Re: RE: Dakota with a gooseneck??"
Previous message: Russ Borman: "What does your trans run at?"
Next in thread: Wisotzkey, Rich: "RE: Ball Joints"
Maybe reply: Wisotzkey, Rich: "RE: Ball Joints"
Reply: Josh Battles: "Re: Ball Joints"
Reply: Rick Barnes: "RE: Ball Joints"
Maybe reply: Shane Craven: "RE: Ball Joints"
Reply: Kevin Reimer: "Re: Ball Joints"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Mail actions: [ respond to this message ] [ mail a new topic ]

This archive was generated by hypermail 2b29 : Fri Feb 06 2004 - 11:48:14 EST