steve,
The dealer was happy to oblige.
BKB
-----Original Message-----
From: Bridges, Bruce [mailto:bbridges@alarismed.com]
Sent: Thursday, August 20, 1998 6:34 AM
To: 'dakota-truck@buffnet.net'
Subject: DML: RE: 2 in and 1 out cat converter
Steve,
As far as I (and the dealer) could figure all R/Ts are supposed to have the
2 in one out cat. As far as header install, It leaves more flexibility in
the down pipes but blocks one of the right headers flange bolts with the O2
sensor. a trade off. If youve got an R/T with a single inlet Cat, its not
right. Get to the dealer and have the right system put on...if you desire
BKB
-----Original Message-----
From: O26ON4@aol.com [mailto:O26ON4@aol.com]
Sent: Thursday, August 20, 1998 4:52 AM
To: dakota-truck@buffnet.net
Subject: DML: 2 in and 1 out cat converter
Please inform me about the thread discussing the 2 in and 1 out cat
converter, do some of the R/T's have this type and some have 1 in and 1 out
like mine?
For header installation, is one better than the other?
Regards,
Steve Waller in Houston TX
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:09:24 EDT