Re: K&N Filters

From: Bob H (torch@triplet.net)
Date: Thu Mar 25 1999 - 06:07:35 EST


At 08:40 PM 3/24/99 EST, you wrote:
>I installed a K&N open element cone filter on my '97 4x4 V8. You can use K&N
>#RE-0930. I used a piece of exhaust pipe with a 90 degree bend to connect the
>filter to the convoluted rubber coming off the intake hat. Go to your local
>autoparts store and tell them you need Walker pipe # 41003. This pipe is a 3"
>inlet, 3" outlet. The smaller end will fit inside the filter and the larger
>end will fit the convoluted hose. You will need to make up a couple on mount
>brackets and have them welded to the pipe to hold it in place. This setup
will
>put the filter in about the same location as the original filter box. I
had to
>cut off about 2" of the small end and about 3/4" of the large end to locate
>the unit where it didn't rub anything. If interested I could get some
pictures
>and e-mail them to anybody that would like to see this setup. Mike
>
>Mike,

I would like to see it, thanks.

Take care,

Bob



This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:13:21 EDT