VERY specific question (I don't want to start the whole debate over again)!
I've seen some home-made intakes that re-use the stock flexible rubber fitting
that attaches to the air hat and some that run a pipe right up to the air
hat... Is there a consensus or explanation why one would be better than the
other? It looks like it would be easier to use the rubber fitting.
I got my K&N cone filter today and I'm just trying to figure out the best way
to rig it.
TIA!
Tom
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 11:46:55 EDT